ADLINK Technology STC2-10WP-AL, User Manual, Page: 90 / 121

80
Parity None
Even
Odd
Mark
Space
A parity bit can be sent with the data
bits to detect some transmission errors.
Even: parity bit is 0 if the num of 1's in
the data bits is even.
Odd: parity bit is 0 if num of 1's in the
data bits is odd
Mark: Parity bit is always 1.
Space: Parity bit is always 0.
Mark and Space Parity do not allow for
error detection. They can be used as an
additional data bit.
Stop Bits 1
2
Stop bits indicate the end of a serial
data packet. (A start bit indicates the
beginning). The standard setting is 1
stop bit. Communication with slow
devices may require more than 1 stop
bit.
Flow Control None
Hardware
RTS/CTS
Flow control can prevent data loss from
buffer overflow. When sending data, if
the receiving buffers are full, a 'stop'
signal can be sent to stop the data flow.
Once the buffers are empty, a 'start'
signal can be sent to re-start the flow.
Hardware flow control uses two wires to
send start/stop
VT-UTF8 Combo Key
Support
Disabled
Enabled
Enable VT-UTF8 Combination Key
Support for ANSI/VT100 terminals
Recorder Mode Disabled
Enabled
With this mode enabled only text will be
sent. This is to capture terminal data.
Resolution 100x31 Disabled
Enabled
Enables/Disables extended terminal
resolution
Putty KeyPad VT100
LINUX
XTERMR6
SCO
ESCN
VT400
Select FunctionKey and KeyPad on
Putty.
Feature Options Description