Installations
11
5. If DIMM does not go in smoothly, do not force it. Pull it all the way out
and try again.
6. Make sure the DIMM is properly installed and locked by the tabs on both
sides of the socket.
Removing a DIMM:
To remove the DIMM, use your fingers or a small screwdriver to carefully
push away the plastic tabs that secure the DIMM at each end. Lift it out of
the socket.
Make sure you store the DIMM in an anti-static bag and must be
populated the same size and manufactory of memory modules. .
2.1.4
Setting Jumpers and DIP Switches
There are jumpers and DIP-switches on the system board of the
NuPRO-761 Series. You can set the jumpers to make the necessary
operations.
Figure 7: Jumper Connector
For any three-pins jumpers (figure 7), the jumper setting is 1-2 when the
jumper connects pin 1 and 2. The setting is 2-3 when pin 2 and 3 are
connected and so on. You see a number
“
1
“
and a
“
3
“
printed on the
circuit board to identify these pins. And also, there is a second way of
indication
–
one of the lines surrounding jumpers is thick, which indicates pin
NO.1.
To move a jumper from one position to another, use needle-nose pliers or
tweezers to pull the pin cap off the pins and move it to the desired position.
PDF created with FinePrint pdfFactory Pro trial version
www.pdffactory.com
