Installations
9
Removing a CPU:
1. Before removing the CPU, turn off the NuPRO-761 Series power; then
wait for about 20 minutes until the heat radiation plate of the cooling fan
and the CPU cool down.
2. To remove the CPU, lift the releasing lever of the Socket 370.
Note: The CPU and the heat radiation plate are hot. They may cause
burns.
To remove the CPU, reverse the installation steps.
2.1.2
Heat Sink Installation
It is highly recommended that only NuPRO-761 Heat Sink + Fan (Figure 4),
designed for use in the chassis be used -- the use of other heat sinks,
including those boxed with CPUs, may result in damage to the NuPRO-761
SBC.
Make sure that good contact is made between the processors and the heat
sinks. Insufficient contact, incorrect types of heat sinks, fans, or thermal
compound used or improper amount of thermal compound applied on the
CPU die can cause the processors to overheat, which may crash the system.
Figure 4: Heat Sink Installation
Heat Sink & Fan
(For P3 processor only)
PDF created with FinePrint pdfFactory Pro trial version
www.pdffactory.com
