ADJ HYDRO BEAM X1, User Manual, Page: 9 / 42

9
S A F E T Y G U I D E L I N E S
This fixture is a sophisticated piece of electronic equipment. To guarantee smooth operation, it is
important to follow all instructions and guidelines in this manual. ADJ Products, LLC is not respon-
sible for injury and/or damages resulting from the misuse of this fixture due to the disregard of the
information printed in this manual. Only qualified and/or certified personnel should perform instal-
lation of this fixture, and only the original rigging parts included with this fixture should be used for
installation. Any modifications to the fixture and/or the included mounting hardware will void the
original manufacturer’s warranty and increase the risk of damage and/or personal injury.
PROTECTION CLASS 1 - FIXTURE MUST BE PROPERLY GROUNDED
THERE ARE NO USER SERVICEABLE PARTS INSIDE THIS UNIT.
DO NOT ATTEMPT ANY REPAIRS YOURSELF; DOING SO WILL VOID
YOUR MANUFACTURER’S WARRANTY. DAMAGES RESULTING
FROM MODIFICATIONS TO THIS FIXTURE AND/OR THE DISREGARD
OF SAFETY INSTRUCTIONS AND GUIDELINES IN THIS MANUAL
VOID THE MANUFACTURER’S WARRANTY AND ARE NOT SUBJECT
TO ANY WARRANTY CLAIMS AND/OR REPAIRS.
DO NOT PLUG FIXTURE INTO A DIMMER PACK!
NEVER OPEN THIS FIXTURE WHILE IN USE!
UNPLUG POWER BEFORE SERVICING FIXTURE!
MAXIMUM AMBIENT OPERATING TEMPERATURE IS 104 ° F (40 ° C)!
NEVER TOUCH FIXTURE WITH BARE HANDS DURING OPERATION, AS SUR-
FACE TEMPERATURE DURING OPERATION MAY REACH 167 ° F (75 ° C)
KEEP FLAMMABLE MATERIALS AWAY FROM FIXTURE!
NEVER LOOK DIRECTLY INTO THE LIGHT SOURCE!
RETINA INJURY RISK - MAY INDUCE BLINDNESS!
SENSITIVE PERSONS MAY SUFFER AN EPILEPTIC SHOCK!
ENSURE ALL CONNECTIONS AND END CAPS ARE PROPERLY SEALED WITH
A DIELECTRIC GREASE (AVAILABLE AT MOST ELECTRICAL SUPPLIERS) TO
PREVENT WATER CORROSION AND/OR ELECTRICAL SHORT CIRCUIT.
IF THE FIXTURE IS EXPOSED TO ENVIRONMENTAL TEMPERATURE CHANG-
ES, SUCH AS RELOCATION FROM A COLD OUTDOOR ENVIRONMENT TO A
WARM INDOOR ENVIRONMENT, DO NOT POWER THE FIXTURE ON IMMEDI-
ATELY. INTERNAL CONDENSATION AS A RESULT OF ENVIRONMENTAL TEM-
PERATURE CHANGE CAN CAUSE INTERNAL FIXTURE DAMAGE. LEAVE THE
FIXTURE POWERED OFF UNTIL IT HAS REACHED ROOM TEMPERATURE
BEFORE POWERING ON.