ADJ HYDRO BEAM X1, User Manual, Page: 19 / 42

19
I N S TA L L AT I O N
FLAMMABLE MATERIAL WARNING
Keep fixture at least 0.7 feet (0.2m) away from any flammable materials, decora-
tions, pyrotechnics, etc.
ELECTRICAL CONNECTIONS
A qualified electrician should be used for all electrical connections and/or instal-
lations.
MINIMUM DISTANCE TO OBJECTS/SURFACES MUST BE 26 FEET (8 METERS)
MAXIMUM TEMPERATURE OF EXTERNAL SURFACE 167°F (75°C)
DO NOT INSTALL THE FIXTURE IF YOU ARE NOT QUALIFIED TO DO SO!
FIXTURE IS INTENDED FOR TEMPORARY OUTDOOR USAGE ONLY!
Fixture MUST be installed following all local, national, and country commercial electrical and con-
struction codes and regulations. Before rigging/mounting the fixture to any metal truss/structure or
placing the fixture on any surface, a professional equipment installer MUST be consulted to determine
if the metal truss/structure or surface is properly certified to safely hold the combined weight of the
fixture, clamps, cables, and accessories.
Overhead fixture installation must always be secured with a secondary safety attachment, such as an
appropriately rated safety cable that meets all local, national, and country codes and regulations.
Fixture ambient operating temperature range is -25º to 104ºF (-10º to 40ºC). Do not use this fixture
when ambient temperature falls outside of this range.
Fixture should be installed in areas outside walking paths, seating areas, or away from areas were
unauthorized personnel might reach the fixture by hand.
NEVER stand directly below the fixture when rigging, removing, or servicing, and allow approximately
15 minutes for the fixture to cool down before servicing.