ADJ HYDRO BEAM X1, User Manual, Page: 8 / 42

8
S A F E T Y G U I D E L I N E S
For Your Own Personal Safety, Please Read and Understand This Manual Completely Before You
Attempt To Install Or Operate This Unit!
• There are no user serviceable parts inside this unit. Do not attempt any repairs yourself, as doing so will void
your manufacturer’s warranty. Damages resulting from modifications to this fixture and/or the disregard of
safety instructions and guidelines in this manual void the manufacturer’s warranty and are not subject to any
warranty claims and/or repairs.
• Do not plug the fixture into a dimmer pack! Never open this fixture while in use, and unplug power before per-
foming and servicing or maintenance!
• Never touch the fixture during operation, as its surface may be hot! Keep any flammable materials well away
from the fixture!
• Ensure all connections and end caps are properly sealed with a dielectric grase (available at most electrical
suppliers) to prevent water corrosion and/or electrical short circuit.
• IF THE FIXTURE HAS BEEN EXPOSED TO ENVIRONMENTAL TEMPERATURE CHANGES, SUCH AS
RELOCATION FROM A COLD OUTDOOR ENVIRONMENT TO A WARM INDOOR ENVIRONMENT, DO
NOT POWER THE FIXTURE ON IMMEDIATELY. INTERNAL CONDENSATION AS A RESULT OF ENVI-
RONMENTAL TEMPERATURE CHANGES CAN CAUSE INTERNAL FIXTURE DAMAGE. LEAVE THE
FIXTURE POWER OFF UNTIL IT HAS REACHED ROOM TEMPERATURE BEFORE POWERING ON.
• NEVER LOOK DIRECTLY INTO THE LIGHT SOURCE! RETINA INJURY RISK - MAY INDUCE BLIND-
NESS OR CAUSE SENSITIVE PERSONS TO SUFFER EPILEPTIC SHOCK!
• Replace shields, lenses, or ultraviolet screens if they have become visibly damaged and their effectiveness is
impaired, due to cracks, deep scratches, or other damage.
• Change the lamp if it has been damaged or thermally deformed.
• The luminaire is intended for professional use only.
• The light source shall only be replaced by the manufacturer, qualified service agent, or a similar qualified
technician.
• Reinforced insulation is located between LV supply and DMX dimming control circuit.
• No insulation located between SELV circuit and DMX dimming control circuit.
• Be sure that the power source is compatible with the required voltage for your unit.
• Do not attempt to operate this unit if the power cord has been frayed or broken.
• Do not attempt to remove or break off the ground prong from the electrical cord. This prong is used to protect
against fire risk in the event of an internal short.
• Disconnect from main power before making any type of connection.
• Do not remove the cover for any reason. There are no user serviceable parts inside.
• Never operate this unit with the cover removed.
• Always be sure to mount this unit in an area that will allow proper ventilation. Allow about 7.9” (20cm)between
this device and a wall.
• Do not attempt to operate this unit if it has been damaged in any way.
• Always mount this unit in safe and stable matter.
• Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed
upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point at
which they exit from the appliance.
• Cleaning - The fixture should be cleaned only as recommended by the manufacturer.
• Heat - This fixture should be situated away from heat sources such as radiators, heat registers, stoves, or
other appliances (including amplifiers) that produce heat.
• The fixture should be serviced by qualified service personnel when the appliance does not appear to operate
normally or exhibits a marked change in performance.