ADJ HYDRO BEAM X1, User Manual, Page: 21 / 42

21
I N S TA L L AT I O N
RIGGING
Overhead rigging requires extensive experience, including but not limited to: calculating working load
limits, understanding the installation material being used, and periodic safety inspection of all installa-
tion material and the fixture itself. If you lack these qualifications, do not attempt to perform the instal-
lation yourself. Improper installation can result in bodily injury.
The installation should be inspected by skilled personnel at least once per year.
SIDE MOUNTING:
TO MAINTAIN IP65 RATING INTEGRITY, THE FIXTURE MUST BE INSTALLED
WITH CABLES FACING TOWARDS THE GROUND AT ALL TIMES. WATER MUST
EASILY RUN OFF AND MUST NOT ACCUMULATE AROUND CABLE CONNECTION
POINTS.
The Hydro Beam X1 is fully operational in three different mounting positions: hanging upside-down,
mounted sideways on trussing, or set on a flat level surface. Be sure this fixture is kept at least 0.2m
or 0.7ft away from any flammable materials. Always use and install the supplied safety cable as a
safety measure to prevent accidental damage and/or injury in the event the clamp fails. Never use the
carrying handles for secondary attachment.
LCD CONTROL
DISPLAY
CABLES
DOWN
LCD CONTROL
DISPLAY
CABLES
DOWN