2
.
1.3. WiFi Setup in Windows XP
• Go to the network connections control panel. Right click
wireless connection
and select
properties
.
• Select the general tab. Set the IP address to one that is in the same subnet as the GRouter’s
default IP of 10.0.2.40 with a subnet mask of 255.255.255.0. For example you could use
10.0.2.41.
• Go to network properties and select the connection tab. Select manual connect to an available
wireless network not automatically connect.
• In the main network connections control panel, create a new wireless network by selecting
"add new network". Use the following settings the the network:
◆
In the Association Tab set the following fields:
■
SSID: "Adept"
■
Network Auth: open
■
Data Encryption : Disabled
■
Check the "this is a computer to computer network(ad-hoc)" box.
◆
In the Authentication Tab leave the settings at the defaults.
◆
In the Connection Tab set the following:
■
Check the "connect when this network is in range" box.
• Click Ok, then Ok again to save the settings.
• Aer a minute or two the computer will automatically connect to the GRouter
• You can now access the GRouter's configuration web pages through a web browser using a url
of "http://10.0.2.40".
-20-
Summary of Contents for GRouter4
