Addi-Data APCI-8001, Commissioning Manual

Page: 29 / 57

CM / C
OMMISSIONING
M
ANUAL
29
4 How to install the motion control board in the PC
You need:
•
Motion control board APCI-8001 or APCI-8008
•
TOOLSET CD
4.1 Installing the xPCI-800x controller
•
Switch the PC off
•
Electrostatically discharge yourself
•
Insert the board vertically from above into the selected PCI slot
(Ensure that you do not touch the gold contacts, if necessary the contacts can first be cleaned with
alcohol)
•
Switch the PC on and start Windows.
Supply voltages of 3.3 V and 5 V must be available at the PCI bus of the target system (PC
motherboard). This can be identified using the diagnosis LEDs listed below, after switching on the
PC. All diagnosis LEDs are on the back (soldered side) of the xPCI-800x controller, on the top edge
of the board. These are small SMD (surface-mounted) light-emitting diodes. See also the sub-
component insertion diagram on the next page.
Device LED Function
APCI-8001
D27 PC supply voltage 5 V (1st LED seen from the
board holder). Must be lit up.
D28 PC supply voltage 3.3 V (2nd LED seen from the
board holder). Must be lit up.
D32 Flashes, showing that the monitor program is
running (1st LED on the side facing away from the
board holder). Must flash when the PC is switched
on.
APCI-8008 D50 PC supply voltage 5 V (1st LED seen from the
board holder). Must be lit up.
D51 Internal supply voltage 3.3 V (2nd LED seen from
the board holder). Must be lit up.
D57 Flashes, showing that the monitor program is
running (1st LED on the side facing away from the
board holder). Must flash when the PC is switched
on.
For most PC systems, the results of the PCI plug and play bios are displayed during the boot process.
An xPCI-800x controller with the following identity (APCI-8001) should be listed there:
Vendor ID: 11AB (hex) and Device ID: 4611 (hex)
Windows 95, 98, Me and Windows 2000 automatically recognises the xPCI-800x board.
For installation, you now require the xPCI-800x TOOLSET CD. There you will find the necessary INF file
to install the board, under the
inf sub-directory. You must register the xPCI-800x controller as a multi-
function board if necessary.