Page | 6
III.
Configuration
The VelociGraph is used to capture pulses from up to 4 sensors.
The VG03 comes with a factory defaults already programmed into the unit. These defaults
work for most situations.
The VelociGraph VG03 is configured using the vg03config program, which sends
configuration data to the VG03 through its serial port. Vg03config is provided with the
purchase of a new VG03, or freely downloaded from the Automated Design Corporation
website at
http://www.automateddesign.com
Vg03Config computer requirements:
OS: Microsoft Windows 7/2000/XP/VISTA
A standard R485 serial port
An RS485 cable (provided with VG03)
Figure 3-1: The Vg03Config software is used to configure the VG03 unit.
Note:
See VIII for interface usage.
