ADC MM702G, User Manual

Page: 12 / 168

Connect Cables
4 MM701G and MM702G User Manual
2 Connect the cables to the modem rear panel as shown above:
•
silver cable to the DSL line port and wall jack
•
black Ethernet cable to the 10Base-T port and to another Ethernet device such as a PC,
hub, or router
•
power cable to the modem power connector and to facility power
3 Refer to “LED Status Indications” on page 5 , to check modem LED status indications.
Ensure that the NIC in the PC and the modem LAN port are both set to either
half- or full-duplex for the transmission direction(s). If you need to change the
modem LAN port setting to match the NIC, follow the procedures in
“Manage
DSL” on page 118 (half-duplex is the default).
Wall jack with
DSL service
DSL LINE
PO
WER
DSL line
port
Power
connector
MD
I
MD
I-X
10BASE-T
CONSOLE
PC, hub or other
network device
10Base-T
port
M0152-B