Adam GC INDICATOR, Manual

Page: 17 / 48

© Adam Equipment Company 2010
• The value to be stored is entered from the keyboard. Enter the numeric
value to be stored using the numeric keys. Then press the
[Pst]
key to
store the value.
• To clear the value from the memory and thereby turn off the check-
counting feature, enter the value "0" and press
[Pst]
.
•
During counting if the count is below the setpoint the “Lo” indicator will
be on, if it is equal to the set point the “OK” indicator will be on and if it
is above the limit the
“Hi”
indicator will be on.
6.3.4 Manually Accumulated Totals
•
The values (weight and count) shown on the display can be added to
the values in the memory by pressing the [M+] key. The "Weight"
display will show the total weight, the
"Count"
display will show the
total accumulated count and the "Unit Weight" display shows the
number of times, the items have been added to the memory for
accumulation. The values will be displayed for 2 seconds before
returning to normal. If the accumulated number exceeds 6 digits the
display will show “diSPEr” , the count is still being stored correctly and
the RS232 printout will still show the correct values.
• The
“Mem”
symbol will be on when there are values stored in the
accumulation memory.
• The scale must return to zero or a negative number, before another
sample can be added to the memory.
•
More products can then be added and the [M+] key to be pressed
again. This can continue for up to 99 entries or until the capacity of the
“Weight”
display is exceeded. When the weight exceeds 6 digits the
display will show “diSPEr” .
•
To observe the total stored value, press the [MR] key. The total will be
displayed for 2 seconds.
• To clear the memory- first press
[MR]
to recall the totals from memory
and then press the [CE] key to clear all values from the memory.
6.3.6 Automatic Accumulated Totals