12. Instant help
In case of an error in the program process, briefly turn off the balance and disconnect from power
supply. The weighing process must then be restarted from the beginning.
Should other error messages occur, switch balance off and then on again. If the error message
remains inform manufacturer.
Help: Fault
The displayed weight does not glow.
The displayed weight is permanently changing
The weighing result is obviously incorrect
Possible cause
• The balance is not switched on.
• The mains supply connection has been
interrupted (mains cable not plugged in/faulty).
• Power supply interrupted.
• (Rechargeable) batteries are inserted incorrectly
or empty
• No (rechargeable) batteries inserted.
• Draught/air movement
• Table/floor vibrations
• Weighing plate has contact with other objects.
• Electromagnetic fields / static charging (choose
different location/switch off interfering device if
possible)
• The display of the balance is not at zero
• Adjustment is no longer correct.
• Great fluctuations in temperature.
• Warm-up time was ignored.
• Electromagnetic fields / static charging (choose
different location/switch off interfering device if
possible)
41
1 Technical Data
1
2 Basic Information (General)
5
2.1 Proper use
5
2.2 Improper Use
5
2.3 Warranty
5
3 Basic Safety Precautions
6
3.1 Pay attention to the instructions in the Operation Manual
6
3.2 Personnel training
6
4 Transportation & Storage
6
4.1 Testing upon acceptance
6
4.2 Packaging / return transport
6
5 Unpacking, Setup and Commissioning
7
5.1 Installation Site, Location of Use
7
5.2 Unpacking
7
5.2.1 Placing/ Remove the transportation lock
8
5.2.2 Scope of delivery
8
5.3 Mains connection
8
5.4 Connection of peripheral devices
8
5.5 Initial Commissioning
9
5.6 Calibration
9
5.7 Calibration Process
9
5.7.1 Calibration Procedure (Non NTEP models)
10
5.7.2 Calibration procedure (NTEP models):
11
5.8 Linearization
12
5.8.1 Linearization non-verifiable models (low resolution)
13
5.8.2 Linearization of non verifiable models (low resolution) and verifiable models
15
5.8.3 Table Linearization points
16
5.9 Position of seals and adjusting switch
17
6 Controls
18
6.1 Keyboard overview
18
6.2 Overview of display
19
7 Operation
20
7.1 Simple weighing
20
7.1.1 Non NTEP models
20
7.1.2 NTEP models
20
7.2 Taring
21
7.2.1 Non NTEP models
21
7.2.2 NTEP models
22
7.3 Parts counting
23
7.3.1 Non NTEP models
23
7.3.2 NTEP models
24
7.4 Adding
25
7.4.1 Non NTEP models
25
Contents