
Once the speed is
selected, holding
down either the ‘UP’
or ‘DOWN’ button
will then activate
the Ascender at
that speed.
Switch off the remote
control. The Remote
control will switch itself off
after 30 min of its last use.
4. Operate the Ascender
5. De-activation
CAUTION
The Remote Control will only work with the Ascender it has
been delivered with. The serial number of the assigned Ascender
is indicated on the Remote Control. In case of using multiple
Ascenders, mark your Remote Controls to avoid any confusion.
When using the remote control, make sure a distance of at least
20 cm (8”) is kept between the remote control and your torso
and/or head. Contains FCC ID: SQGBT700.
Note
Remote Control does not work if Emergency Stop is pressed or
if the Ascender is switched off. Once the Ascender is switched
back on again the Ascender can be used manually. The remote
connection needs to be re-established by turning the Remote
Control off and on again.
Hold
down
53
Summary of Contents for ACX
