
General guidelines and warnings
»
Battery charging must be conducted
in a safe area away from combustible
or other
fl
ammable materials
»
Do not charge the Battery unattended
»
When hot, allow the Battery to
cool down to room temperature
before charging
»
Immediately remove the Battery
or charger from service:
-
If there is visible damage to the
housing, cables or connectors,
including the Battery Connectors
on the Ascender
-
If the Battery has been dropped
as there may be internal damage
that isn’t visible
-
If the Battery emits an unusual smell,
feels hot, produces smoke, changes
shape, or appears abnormal in
any other way. Since a delayed
reaction can occur, observe the
Battery for a minimum of 15 minutes
in a safe area and away from any
combustible material
»
Only use the original ActSafe ACX
Battery Charger
»
Do not disassemble or modify
the Battery in any way. The Battery
contains safety and protection
electronics, which, if damaged,
may cause the Battery to
generate heat, explode or ignite
»
Do not expose the Battery to water
Battery Management System (BMS)
The ACX Batteries have built-in safety
electronics which constantly monitor
and manage the charging levels,
temperature and energy output of all
the cells in these batteries. The BMS
is designed to shut down the Battery
temporarily in case of overheating or
overcharging to avoid battery damage
and prevent the Battery from becoming
unstable or catching
fi
re. In case of a
too low charge (deep discharge) or
worn out battery cells, the BMS may
shut the Battery down permanently.
This is to prevent the Battery becoming
unstable and dangerous to the user.
When used and charged correctly, the
BMS will increase the safety and service
life of the Battery substantially.The BMS
cannot protect the Battery from severe
misuse as mentioned earlier. Follow
the ActSafe Battery care instructions
to enable a long battery life.
DANGER
Do not use any other battery
chargers as they can damage
the Battery and may create
toxic gases which cause a
fi
re.
35
Summary of Contents for ACX
