4
ActronConnect Installation & Commissioning Guide - Website
Doc. No.9590-1001 Version No.3.0 150901C
INSTALLATION INSTRUCTIONS
1.0 ActronConnect Power Supply & Module Installation Procedures:
1.1 Power Supply Installation Procedures:
Step 1.1.1.
Isolate electrical power to the air conditioner at isolator or main switchboard.
Step 1.1.2.
Remove lid from indoor unit electrical panel.
Lid- Electrical
Panel
Indoor Unit
Step 1.1.3.
Mount the ActronConnect power supply kit, using either of the two options below, to the base of
the electrical panel as shown below:
Option 1 (Using the 2x4mm M3 screws):
2x4mm M3
Mounting Screws
NOTE: Use mounting screws when holes
are existing in Electrical Panel base.
Ensure that the earth ring terminal is pointing towards
the right side (
looking at the electrical panel
)
Power Supply Kit
(Pre-wired Supplied)
“PLUG C” (RJ45 Data) & Cable
to ActronConnect Module
Ensure the power supply ventilation
holes are NOT covered by the excess
cables or other foreign matter.
Option 2 (Using the Double Sided Tape):
Double Sided
Tape
Power Supply Kit
(Pre-wired Supplied)
“PLUG C” (RJ45 Data) & Cable
to ActronConnect Module
Ensure that the earth ring terminal is pointing towards
the right side (
looking at the electrical panel
)
NOTES: Use double sided tape where there are no holes in the Electrical Panel base.
Make sure that the base of the electrical panel and the power supply are
clean and free of dirt or dust in order to provide a strong tape adhesion.
Ensure the power supply ventilation
holes are NOT covered by the excess
cables or other foreign matter.
