Acteon ImplantCenter M+, User Manual, Page: 19 / 44

6 Medical device use
6.1 Preparing the medical device
6.1.1 Connecting the medical device to the electrical network
l
Set the ON/OFF switch to O position (off).
l
Connect the power cord to the device's mains connector.
l
Connect the mains power cord to the mains socket equipped with an earthing pin.
l
If necessary, connect the potential equalisation cable to the medical device's potential equalisation
terminal marked with
.
6.1.2 Footswitch
The practitioner can start up the medical device using the footswitch. Press the footswitch to automatically
start the ultrasounds on Piezotome® M+ and Newtron® handpieces. The footswitch also controls the I-Surge LED
micromotor.
The footswitch equipped with its cord cannot be disconnected. Its weight and antislip pad ensure good stability.
The light function remains active for approx. 9 seconds after the footswitch is released.
6.1.3 Installing the footswitch
The footswitch must be positioned near the operator's feet and must always be within reach.
6.1.4 Connecting the I-Surge LED micromotor
Check for any traces of humidity on the I-Surge LED cord connector. Wipe them off if there are any.
Connect the cord connector to the socket, by aligning the red indexing points and by avoiding rotation
movement. Place the I-Surge LED micromotor on the support.
6.1.5 Connecting the Piezotome
®
M+ handpiece
Check for any traces of humidity on the handpiece cord connector. Wipe them off if there are any.
Connect the cord connector to the socket, by aligning the red indexing points and by avoiding rotation
movement. Place the handpiece on the support.
6.1.6 Connecting the Newtron
®
handpiece
Check for any traces of humidity on the handpiece cord connector. Wipe them off if there are any.
Connect the cord connector to the socket, by aligning the red indexing points and by avoiding rotation
movement. Place the handpiece on the support.
6.1.7 Installing the irrigation system
Equipment: one sterile M+ irrigation line, 10 single-use sterile clips, one sterile perforator with cap, one
bracket, one solution bag.
1. Insert the bracket into its holder
2. Open an irrigation line with its cassette
3. Slide the cassette into its support on the side of the medical device
4. Install the clips on the handpiece cord
5. Attach the irrigation line
6. Connect the end of the irrigation line to the water inlet on the handpiece
7. Install a bag on the bracket
8. Remove the cap from the perforator and insert the perforator into the solution bag.
The medical device must always be used with SATELEC® M+ irrigation lines.
The medical device is not designed to administer medication and must only be used with bottles or bags
containing no more than 1 litre of physiological saline solution or sterile water.
User Manual • ImplantCenter™ M+ • J27251 • V1 • (13) • 09/2013 • NO25EN010A - Page
17
/
42