Acteon ImplantCenter M+, User Manual, Page: 13 / 44

3 Removal from packaging,
installation, connections
3.1 Removing the medical device from its packaging
When you receive your medical device, check for any damage that may have occurred during transportation.
If you have received this medical device by mistake, please contact the supplier to arrange for it to be
collected.
If you have any questions or requirements, contact your supplier.
The ImplantCenter™ M+ includes the following items:
l
an ImplantCenter™ M+ unit
l
an I-Surge LED implantology motor and cord
l
a multifunction footswitch
l
two peristaltic pump recesses
l
two Irrigation solution brackets
l
five irrigation lines with 10 single-use sterile clips
l
two handpiece supports
l
30 single-use, sterile irrigation line perforators
l
a power cord
l
a [J27260] Quick Start guide, a [J27261] Quick Clean guide
l
an attachment kit.
3.2 Installing the medical device
Place the control unit in the position that is suitable for your activity. Check that the cords do not hinder the
movement or free circulation of anyone. The medical device must be placed on a secure and flat surface or a
surface with a maximum slope of 5 degrees.
Fix your medical device using the attachments provided to ensure that the device cannot be removed without
the use of a tool.
Adjust the position of your medical device to correspond to your angle of vision and the characteristics of your
workstation, e.g. lighting or distance between the user and the medical device.
Ensure that your medical device is readily accessible.
Do not install your medical device near or on another device.
3.3 Installing cords
Check that the cords do not hinder the movement or free circulation of anyone. Make sure that it is not possible
to wheel over or walk on the different cords. Cords attached to their handpiece or I-Surge LED micromotor
must be readily accessible. Make sure that the cord is slack during use.
Never rotate the handpiece connector on its cord as this can damage your medical device.
Never wrap the handpiece cord around the medical device. Do not put the medical device cords in a
cable cover or a cable tray.
3.4 Connecting the medical device to the electrical network
Switch the medical device OFF (position O) and check that the mains voltage is compatible with that indicated
on the medical device. Next, connect the cord to the wall socket in compliance with the standards in force in
the country of use.
The medical device is equipped with a protective ground connection and must be connected to a mains power
supply with a protective ground.
User Manual • ImplantCenter™ M+ • J27251 • V1 • (13) • 09/2013 • NO25EN010A - Page
11
/
42