88
A1040 MIRA 3D
© 2021 Acoustic Control Systems – ACS Group
Getting started
Getting started
26.3 Preparation for work
In order to start or finish work with the tomograph some preparation steps are
required. The description of these steps can be found in this chapter.
Switching on the tomograph
·
Press and hold the button power up/down for at least 3 seconds. LED "ON"
starts blinking. During that time the operation system of the instrument is
being loaded. Finishing of the loading process is indicated by changed state of
"ON". The LED lights constantly.
·
The tomograph is now ready to establish the connection to hotspot, LED
"CONNECT" is blinking.
Starting the app
·
Before launching the app you need to switch on the hotspot. It can be done by
swiping at the upper part of the table screen to call quick start menu. In the
menu activate the hotspot as shown below.
·
Successful connection of the tomograph to the hotspot will be indicated by the
little number [1] next to the hotspot icon, see the following image.
