42
A1040 MIRA 3D
© 2021 Acoustic Control Systems – ACS Group
Trouble shooting
Trouble shooting
16
Trouble shooting
Problem
Possible Reason(s)
Action
Main Device does
not switch on.
The ON LED is not
flashing green after
pressing the ON
key for three
seconds.
Rechargeable
Battery not charged
Press the ON Key short to check the
Battery charging status. If the status is
low (e.g. the red LED that equals 10 %
is blinking) charge the batteries.
The Main Device has
a malfunction that
can only be
determined by
trained service
personnel
Send the device back for repair in its
original box, or hand it over to a
designated collection point for
recycling.
The product must not be disposed of
with the domestic waste.
Main Device does
not initialize the
hardware and boot
the firmware.
The ON LED is
flashing green after
pressing the ON
key for three
seconds but is not
constantly glowing
after some time.
The software of the
Main Device is
malfunctioning or
was damaged.
Switch off the Main Device by pressing
the ON key for three seconds.
Switch on the Main Device by pressing
the ON key for three seconds.
Try to perform a firmware update
according chapter
.
The Main Device has
a malfunction that
can only be
determined by
trained service
personnel
Send the device back for repair in its
original box, or hand it over to a
designated collection point for
recycling.
The product must not be disposed of
with the domestic waste
Main device is not
detected by mobile
unit.
Laser does not
work or is blurred
Dirt or or a small
item is blocking the
laser beam outlet.
Switch off the laser LEDs by the control
software.
89
