10 of 23
3. Press
UP/DOWN
to change the time.
3. Press
ENTER
the display shows “Confirm?” Press
ENTER
to confirm the
change or
ESC
to not confirm
The display shows again:
“RINSE PROLONGATION”
4. Press the key
MENU
to pass to the following menu
HYDRAULIC SUPPLY
The display shows:
“HYDRAULIC SUPPLY”
Continue as it follows:
1. Press
ENTER
to confirm.
The display shows:
“MIN TEMP. 30 °C “
This is the minimum for the water inlet temperature
If the temperature goes down below this value it appears
the alarm „LOW WATER INLET TEMPERATURE“
2. Press
UP/DOWN
to change the temperature.
3. Press
ENTER
to confirm
or
4. Press
MENU
to pass to the following menu
The display shows:
“FLUX CONTROL “
(OPTION) Check if the inlet water quantity is enough
With the keys
UP/DOWN
is also selected
„FLOWMETER“ (OPTION) or “NOT CONNECTED “
If the display shows:
“FLOWMETER “
5. Press
MENU
The display shows:
“IMPULSE/LITER “
Press UP/DOWN
to change the data
Summary of Contents for ELECTRONIC 3
