ACRS ELECTRONIC 3, Instruction Manual & Recipes

Page: 18 / 52

instruction for the service people
18
LOCATION
The machine has to be installed in a "normal" room or environment, i.e. it has to be covered,
without dust, without risks of explosions and properly lit and ventilated.
INSTALLATION AND CONNECTIONS
See installation plan included with the machine and data plates on the connections.
The installation of the dishwasher requests the previous preparation of the electric and
hydraulic connections. Refer to the plan relating to the model of your choice for dimensions
of piping, cables and wall switch.
In order to prevent damages due to the emission of steam from the machine, make sure that the
materials are not affected by this emission.
Remove the panels and position the machine over the connections. Place the standard supplied
rubber absorbers under the regulation feet of the machine and adjust them to level it, if
necessary.
Connect the load and unload tables. At the exit side the table is equipped by an end run limit
switch. For the electrical connection, see fig.4.
The supplier of detergents has to provide the respective dispensers.
Attention : The use of detergents and hygienic products requests the use of automatic
dispensers, as it is not possible to obtain constant quantities when pouring the detergent
directly into the tank and there is furthermore the risk that brown spots appear on the surfaces
due to the reaction of chloride.
The introduction of the product must take place near the suction tube of the pump and its
minimum distance from the bottom must be 15 cm in order to avoid corrosion.