13
the change to [Yes] and exit. Operation examples are as follows:
Note: 1. In practical operation, in order to ensure reliable communication, it is appropriate to set the monitoring
instrument's communication address in the order of 1-245 (the address cannot be repeated), and set the
communication baud rate as 9600.
2. When only one AIM-R100 communicates with AID150, the correspondence address of AIM-R100
must be set to 1 and the baud rate is 9600.
(6) Protection Settings
[Protection setting] is the residual current detection threshold setting. Select [Protection setting] in the
programming mode to set the residual current loop number, loop alarm value and trip time. Press "Self-
check/Return" to exit when the setup is complete. Press "Enter" to save the change to [Yes] and exit. Operation
examples are as follows:
(7) Empty the record and version information
Clear fault record eliminates all previous fault records and re-records at the current time.
Version Information is used to display information about the meter model and software version. The
operation is relatively simple, as follows:
(8) Enable and close some unused circuits
[Circuit Setting] AIM-R100 can be connected to 12 aback-0.66 /L-20 remaining current transformers at
most, "circuit setting" can close off the unused part of the circuit that is not connected to the transformer, so as to
avoid the instrument identification as the wiring failure of the transformer. The operation is as follows:
Set Comm
Addr:01 Baud:9600
Set Comm SetAlarm
Set Pwd Set Time
Set Comm SetAlarm
Set Pwd Set Time
Save Settings？
Yes No
Press Up and Down to set value,
press Esc to save or exit
Press Up and Down to
select the option
Press Enter to confirm
Press Up and Down to
select the option
Press Enter to confirm
Loop All
Alarm Value 10mA
Set Comm SetAlarm
Set Pwd Set Time
Set Comm SetAlarm
Set Pwd Set Time
Save Settings？
Yes No
Press Up and Down to set value,
press Esc to save or exit
Press Up and Down to
select the option
Press Enter to confirm
Press Up and Down to
select the option
Press Enter to confirm
Set Loop Language
Clr SOE Sw Info.
Press Up and Down to
select the option
Press Enter to confirm
Clear SOE？
Yes No
Set Loop Language
Clr SOE Sw Info.
SN:2015121203
Software:484 V1.06
Press Up and Down to
select the option
Press Enter to confirm
