20
b. Place the Pole Display properly into the bracket
making sure that the connectors are slipped
inside of the pole (upwards.)
c. Attach the two display pole screws (2 larger
screws) to securely fasten the pole to the bracket.
d. Finally, attach the bracket-plate to the bracket
and fasten it with the 4 smaller screws.
3. Place the scale in the area where it will be used which
should be a rigid and level surface. Using the leveling
feet and leveling gage, make sure that scale is level. The
leveling gage is located on the right-side rear of the scale
by the pole bracket; the leveling feet are located at the
bottom of the scale chassis.
Note:
The leveling foot
located on the front-right side of the bottom of the scale
(closest to the numeric keypad) is
not
adjustable. Please
do not
try to adjust this leveling foot; instead, use the
other three feet to adjust the level.
4. Place the platter on the scale platform and then connect
the AC cord to the LS-100. The AC cord (power cord)
goes connected to the left-side of the scale; there is a
label on the scale by the connector ports which indicates
what each connector is for.
5. Make sure that the power switch is in the OFF position
which is located above the AC cord connector.
6. Plug the scale into an AC source.
Note:
The AC source
must be 85V ~ 240V DC 50/60 Hz +5%.
7. Turn the power switch to the ON position. The scale will
do the display test and then go to zero.
8. Press
the
FEED
key 2 or 3 times collecting the labels as
they are fed out each time you press the key.
9. The scale should be in the
Initial State
; all the displays
should read:
This is the
Initial State
. Most directions and instructions in this manual
will begin with setting the scale up to the
Initial State
. Please
familiarize yourself with how to get the scale to the
Initial State
: this
state is achieved by simply turning the scale on. You are now ready to
use the scale.
