10
Installing Labels:
Once you have followed the instructions for removing labels you can
install a new label roll by taking the new label roll and remove about 30
cm (approx. 12”) of labels from the backing paper of the new label roll
and then do the following:
1) Place the new label roll onto the Label Roll Spool (b).
2) Thread the backing paper through the Pressure Plate (c).
3) Next, thread the backing paper
between the Label Guide bobbin
(g) and (h).
4) Then, thread the backing paper
over the Platen (d) and over the
Label Guide bobbin (i) so that the
backing paper is
NOT between
Platen (d) and the Label Guide
bobbin (i)
.
5) Next, thread the backing paper under the Label Guide bobbin (j) so
that the backing paper is
NOT between Platen (d) and the Label Guide
bobbin (j)
.
6) Then, wind the backing paper over the Pick-up Motor Shaft (e)
about 1 turn.
7) Next, fit the Pick-up Clamp (f) over the Pick-up Motor Shaft (e) so
that the backing paper slides through the slit located on the Pick-up
Clamp (f). Also, make sure that the Pick-up Clamp (f) slides all the
way into the Pick-up Motor Shaft (e)
8) Then, wind the Pick-up Clamp (f) until the edge of the first label is
aligned with the Platen (d). When done, make sure that the lever
located on top of the Pick-up Clamp (f) is folded down against the Pick-
up Clamp (f).
