Acer Veriton 3000, Service Manual

Page: 100 / 140

68 Chapter 4
BIOS Message Action/FRU
CPU Clock Mismatch 1. Enter BIOS Setup and load the default settings.
2. Ensure that the BIOS setting for the processor is set
correctly.
DMI Table Was Destroyed 1. Flash the BIOS.
Equipment Configuration Error 1. Ensure that the system configuration set in BIOS Setup
is correct.
2. Enter BIOS Setup and load the default settings.
3. RTC battery.
4. Main board.
Floppy Disk Controller Error
Floppy Drive A Error
Floppy Drive B Error
1. Diskette drive cable/connection.
2. Diskette drive.
3. Main board
Floppy Drive(s) Write Protected
Hard Disk Drive(s) Write Protected
1. Ensure that the diskette drive is not set to [Write
protect] in the Security Options in BIOS Setup.
2. Load default settings in Setup.
I/O Parity Error 1. Main board.
IDE Drive 0 Error
IDE Drive 1 Error
IDE Drive 2 Error
IDE Drive 3 Error
1. Enter BIOS Setup and load the default settings.
2. Check the IDE drive jumper.
3. IDE hard disk drive power.
4. IDE hard disk drive cable/connection.
5. IDE hard disk drive.
Insert system diskette and press <Enter> key to reboot 1. Insert a bootable disk into the floppy disk drive or
remove this disk if a hard disk is installed.
IRQ Setting Error
Expansion ROM Allocation Fail
I/O Resource Conflict(s)
Memory Resource Conflict(s)
1. Load default settings in Setup.
2. Enter BIOS Setup and set the
Reset Resource
Assignments
of the
PnP/PCI Options
to Yes;
then reboot the system.
3. Remove all adapter cards that are NOT factory-
installed and then reboot the system.
On Board Parallel Port Conflict(s)
On Board Serial Port 1 Conflict(s)
On Board Serial Port 2 Conflict(s)
1. Enter BIOS Setup and load the default settings.
2. Remove all adapter cards that are NOT factory-
installed and then reboot the system.
Onboard xxx... Conflict(s) 1. Enter BIOS Setup and load the default settings.
2. Remove all adapter cards that are NOT factory-
installed and then reboot the system.
PCI Device Error 1. Load default settings in Setup.
2. Enter BIOS Setup and set the
Reset Resource
Assignments
of the
PnP/PCI Options
to Yes,
then reboot the system.
3. Remove all adapter cards that are NOT factory-
installed and then reboot the system.
Press Ctrl + Alt + Esc key to enter Setup or F1 key to
continue 1. Press Ctrl+Alt+Esc to enter Setup and reconfigure the
system.
Press Esc to turn off NMI, or any key to reboot 1. Press Esc to reject the NMI error or press any other
key to reboot the system.
PS/2 Keyboard Error or Keyboard Not Connected
PS/2 Keyboard Interface Error
PS/2 Keyboard Locked
1. Reconnect the PS/2 keyboard and mouse.
2. Enter BIOS Setup and load the default settings.
3. PS/2 keyboard.
4. PS/2 mouse.
5. Main board.
PS/2 Pointing Device Interface Error
PS/2 Pointing Device Error
1. Reconnect the PS/2 keyboard and mouse.
2. Enter BIOS Setup and load the default settings.
3. PS/2 mouse.
4. PS/2 keyboard.
5. Main board.