Index
lxxxix
3.5.2 Removing the Power Supply
Before you can install components into the housing, you must first remove the power
supply. Follow these steps to remove the power supply:
1.
Arrange the legs as shown in the figure and put the housing in a flat position.
2.
Locate the power supply. Remove any attached power cables, remembering where
they were located (refer to Figure 1-1). Remove the screw from the top rear of the
chassis, then press the tab located on top of the housing frame just above the power
supply.
Summary of Contents for Power
