Acer Altos R700 Series, Product Manual

Page: 42 / 80

2 Assembling the System
34
3 If it isn’t installed, install the power supply air baffle. All cables
from the power supply should route through the notch in the
bottom of the baffle.
4 Connect the SCSI cable to the SCSI connector on the server board.
Route the cable between the memory connectors and the full
height PCI riser, through the clips on the side of the processor duct,
through the notch in the top of the power supply air baffle, to the
connector on the backplane board.
Note : It may be easier to route the SCSI cable after the full length
PCI riser card is installed.
5 Ensure that the front panel cable is connected to the front panel
board, routed over USB cable to the backplane, and connected to
the matching connector.
AR700-e.book Page 34 Tuesday, September 10, 2002 2:31 PM