10-8
94MS42 Rev.B1 S/W Ver 2.06
•
Unplug the drive motor electrical connector from the control box and
position both frames near the mid-travel position.
•
Remove three linear bearing retainer block screws using a
5
/
32
" Allen
wrench.
•
Lift up the frame assembly about 2" (51 mm) and slide the bearing block
assembly backward off the shaft, support the frame to prevent contact
with the shaft.
•
Remove the bearing from the retainer block.
•
Install in reverse order.
Frame Glass Replacement
Note:
Wear leather gloves and safety glasses when performing this
procedure.
•
Open the frame to be changed.
!
Cl
The glass frame could suddenly move up as soon as the
glass (weight) is removed. Secure the glass frame to the tray
cable ties or heavy duty tape.
•
Remove the black silicone fillers in each corner on the front edge of the
glass frame.
•
Push up on the glass from under the frame. Hold it up about 12" (305
mm) off of the frame.
•
Disconnect both vacuum hoses and lift out the glass.
•
Install new glass in the reverse order.
Summary of Contents for AP42CL 8000
