Accuprint AP42CL 8000, Service Manual

Page: 30 / 134

4-2 94MS42 Rev. B1 S/W Ver. 2.06
dim. Enter the lock level desired.
• Press the
V
key to set entry.
• If the Lock Level is set for 2, 3 or 4, the Exposure window will read
[codE]
. Enter your 3 digit code.
• Press the
V
key.
• Press the
0
key.
• Press the
V
key.
Note: If you want a higher Lock Level after you have completed the
Integrator Program Set Up and/or made any changes return to
Lock Level Feature and set the lock level described in Lock Level
Description and Operation.
Lock Level Description and Operation
[0000]
Lock Level 0
The Vacuum window will read
[0000]
.
[0001]
Lock Level 1
The Vacuum window will read
[0001]
. Locks functions for seconds, enter,
vacuum and intensity per memory. Once this mode is turned ON and the
set up programing has been completed, enter all needed information into
a memory location. Then press the
U
key, the Memory window will
read
[Ac]
and the Exposure window will read
[LocK]
. Press the
V
key to
turn the lock for this memory ON or OFF, then press the
U
key. When
the lock is turned ON, a decimal point will be displayed after each digit
in the Memory window.
[0002]
Lock Level 2, 3
The Vacuum window will read
[0002]
or
[0003]
. Locks functions for
seconds, enter, vacuum and intensity per memory and Integrator Program
Set Up Features. Before this mode is turned ON, enter all needed
information into a memory location. Then press the
U
key, the Memory
window will read
[Ac]
, the Vacuum window will read
[_oFF]
and the
Exposure window will read
[LocK]
. Press the
V
key to turn the lock ON
or OFF for this memory. When the lock is turned ON a decimal point
will be displayed after each digit in the Memory window. Once this level
is turned ON you will not be able to unlock the features described above
without the Lock Code. See Setting or Changing your Lock Code Feature.
[0004]
Lock Level 4
The Vacuum window will read
[0004]
. This locks all functions. When
the lock is turned ON, a decimal point will be displayed after each digit
in the Memory window. Once this level is turned ON and the set up
programing has been completed, before you can change any programed
features or the exposure statistics you must use the Lock Code to set the
Lock Level back to 0, see Setting or Changing your Lock Code Feature.