Accu-Steam™ Gas G2 Installation and Operators Manual
MP5017-1702
PAGE 11
Installation/Operational Checklist &
Warranty Registration Form
GAS ACCU-STEAM G2™
MP5019-1612
Page: 2
Gas Pressure Readings Continued
(To be taken with all the gas equipment in the facility turned ON and operating) :
Yes
No
Yes
No
Yes
No
or
DC-mV
Temperature & Operational Verification :
°F
Yes
No
Yes
No
Yes
No
Yes
No
I accept and submit this Installation/Operational Checklist & Warranty Registration Form as complete and accurate:
Restaurant/Facility Manager Approval:
Signature
Printed Name
Date:
Fax
AccuTemp Products, Inc
Attn: Warranty Administration
8415 North Clinton Park Dr.
Fort Wayne, IN 46825
Attn: Warranty Administration
260 469-3045
Attn: Warranty Administration
Does the Supply Gas Pressure coming into the Griddle
exceed 13"WC
?
If yes:
An external gas regulator needs to be connected to the supply gas line prior to the griddle connection?
Note:
An external regulator
should not be used
unless the supply gas pressure
is more
than
0.5 psig (13"WC)
.
Using a 1/8" NPT fitting, has the Dual Regulating Valve been adjusted to
5
"WC = Natural Gas (
10
"WC = Propane)?
Does the
Flame Sense Signal
reach a
minimum
value of
2.5 DC-µA
or
30 DC-mV
(could be higher)?
What is the
maximum
value of the
Flame Sense Signal
after the griddle reaches the
operating temperature?
Note:
A valid DC-milli-Volt
(DC-mV
) value can only be taken using
the approved
AccuTemp DC-mV Probes (PN: ATR-FT003)
; which can be purchased from
AccuTemp or an approved distributor.
DC-µA
What is the customer's normal operating Thermostat temperature for the Griddle?
Using a
weighted contact temperature probe with digital thermometer
, does the
surface
temperature (°F)
match
the normal
operating
temperature (°F) set on the Thermostat?
Note:
DO NOT
use an
infrared
or
flat-top
mercury thermometer.
Note:
If the
operating
temperature is
250°F
, then set
Thermostat
to
300°F
and
verify
surface temperature.
If the operating
temperature is 400°F, then set Thermostat to 400°F and verify surface temperature does not exceed 396°F on the high side
of the temperature drift/cycle.
Using a 9 square-grid-pattern on the griddle surface, are the surface temperatures consistent (±5°F)?
Does the Griddle heat light cycle OFF/ON once the surface temperature has reached the set temperature?
Does the unit operate properly for 15 minutes after the griddle has reached operating temperature?
Summary of Contents for GG24A
