Acclaim Lighting Unity SNS2019, User Manual

Page: 20 / 56

18
FITTING A SNOOT
Snoots help to reduce or eliminate light spill into unwanted areas. The full and half snoots
available from Acclaim Lighting are attached to the Unity fixture in the same way.
Tip: Adding a snoot is made easier when the fixture’s front face is pointing vertically upwards.
1 Use a 1/8” (3mm) Allen (hex) wrench to remove the four bolts that secure the front ring
and remove the ring.
2 Remove the front ring and place the snoot onto the front of the fixture. The snoot
mounting holes must align with the same threads that are used by front ring. There are
also two slots either side of the snoot which must fit onto the small locating pins either
side of the fixture.
Full or half
snoot
3 Replace the front ring.
4 Tighten the bolts evenly.