Acclaim Lighting Unity SNS2019, User Manual

Page: 14 / 56

12
FITTING A PENDANT MOUNT SET
IMPORTANT: The pendant mount requires a solid, weight-bearing horizontal
mounting surface. You also need to source mounting hardware appropriate to the
mounting surface, rated to safely hold the weight of the total fixture plus safety
factor. If the power/control cord will be fed up through the pole, a hole will also need
to be made through the mounting surface to accommodate the cord.
TO FIT A PENDANT MOUNT SET
1 Remove the existing yoke from the Unity fixture:
•
Lay down a protective surface, such as a thick
blanket or the foam insert from the Unity box,
and place the Unity fixture face down on the
surface.
•
Use a 5/16” (8mm) Allen (hex) wrench to
remove the large pivot bolt from each side of
the yoke.
•
Gently pull the arms of the yoke out from the
fixture body so that the pivot points disengage
- thus freeing the yoke from the fixture body.
2 Transfer the two pivot cups from the original yoke
to the new pendant yoke:
•
Use a #2 Phillips driver to remove the three
screws holding each pivot cup to the arms of
the original yoke.
•
Using the removed screws, attach each pivot
cup to the outside of the arms of the new
pendant yoke.
3 Separate the top bracket from the new pendant
yoke:
•
Use a 3/16” (4mm) Allen (hex) wrench to
remove the two bolts (
A
) that lock the NPS pipe
in place within the top bracket.
•
Use a 1/8” (3mm) Allen (hex) wrench to remove
the two small bolts (
B
) that secure the cover
plate to the top bracket.
•
Slide down the cover plate and unscrew the top
bracket from the NPS pipe.
Tip: Keep the cover
plate safely in place on the NPS pipe.
Pivot
bolt
A
A
B
B
Cover
plate
Top
bracket
Pivot cup