8
www.acclaimlighting.com
FITTING A BASE PLATE
Two types of base plate are available, both have an outside diameter of 4.45” (113mm); one
is solid, for direct surface mounting, while the other is hollow for use on standard 4” round
electrical outlet boxes. Both base plate types are attached to the Dyna Accent Mini fixture
in the same way. See “Dimensions” on page 22.
Note: The pillar has a standard internal 1/2”
NPS pipe thread.
TO FIT A BASE PLATE
1 First determine whether the cable will run down through the pillar and through the base
plate, or will run externally. If the cable is to run externally, see “To remove the cable from
the pillar” on page 6.
2 If the cable is run down inside the pillar, thread the cable through the center hole of the
plate and also through the large
Lock nut
.
3 Bring the lock nut up through the center hole of the base plate and insert it into the
internal thread of the pillar. Tighten using a 1” (26mm) wrench.
Pillar
Base plate
Lock nut
4 Secure the base plate to the surface/electrical outlet box using four suitable screws or
bolts (preferably with countersunk heads).
