18
www.acclaimlighting.com
FURTHER INFORMATION
TROUBLESHOOTING
NO LIGHT OUTPUT IS VISIBLE WHEN EXPECTED.
•
Check that power is correctly applied to the fixture and that there is no damage to the
power input cord.
•
Use an RDM tool to perform an emitter test.
•
Check that the DMX address set within the fixture matches that being output by the
controlling source device.
•
If wired DMX control is being used, check the DMX output near to the source to confirm a
valid signal is being originated.
•
If wired DMX control is being used, check that the DMX + (hot) and DMX - (cold) lines
have not been crossed.
•
If Aria wireless DMX control is being used, check that the fixture is set to the same wireless
address as the transmitter (the wireless address is independent of the DMX address). Try
changing the transmitter and receiving fixture(s) to different (but equal) wireless channels
to check for clear space in the radio spectrum from interference by other devices, such as
WiFi.
DIMMING AND/OR CHASE CHANGES ARE JERKY WHEN USING ARIA.
•
Check for WiFi sources near to the transmitter or receiver devices. Try changing the
transmitter and receiving fixture(s) to different (but equal) wireless addresses to check for
clear space in the radio spectrum from interference by other devices.
