Accelerated 6310-DX, User Manual

Page: 46 / 235

6310-DX is trying to setup cellular modem. Wait up to 2 minutes to allow the 6310-DX is trying to setup cellular modem. Wait up to 2 minutes to allow the
process to finish. If status LED continues to flash yellow after several minutes, process to finish. If status LED continues to flash yellow after several minutes,
continue with below step(s): continue with below step(s):
1. Login to web UI. Open Configuration page. Verify the Modem -> Enable check box is
selected.
2. If the 6310-DX continues to flash yellow for more than 5 minutes, consult the
troubleshooting steps for a flashing white status LED.
Flashing White Flashing White
Ethernet link detected, connection is in progress. Ethernet link detected, connection is in progress.
Wait up to 2 minutes. If LED status continues, determine the number of Signal Strength LEDs:
None
• Power off the 6300-CX, swap the antennas on the back of the 6300-CX, and power on the
6300-CX. If this resolves the connectivity and the 6300-CX displays two or more bars of signal
strength, this may indicate that one of the antennas is faulty. You can continue to use the
6300-CX, but we suggest that you eventually order a replacement set of antennas to improve
signal strength even further.
• If swapping the antennas did not resolve the issue, verify the SIM card is inserted properly.
Power cycle the 6300-CX after re-insterting the SIM card. Wait 30 to 60 seconds. If the
problem persists, the 6300-CX unit cannot detect the SIM and the router may need to be
replaced.
One
Relocate the 6300-CX to an area with better signal reception.
Two or More
Verify that the embedded cellular modem firmware of the 6300-CX matches carrier type.
User Manual
Page 46 Page 46 6310-DX