19
For more cool Wattage products visit our website at http://watt-age.globalhobby.com
❑
# 1 Phillips Head Screwdriver
❑
Electric Drill
SECTION 8: INSTALLING THE SERVOS
YOU'LL NEED THE FOLLOWING SUPPLIES:
❑
1/16" Drill Bit
❑
Ernst Airplane Stand
Step 1: Installing the Servos
❑
Install the rubber grommets and brass collets onto your
elevator and rudder servos. Make sure to install the collets
with the flanges toward the bottom of the servos.
❑
Set the servos into the servo tray taking note of their
locations and the positions of the servo output shafts.
☛
The sides of the servos should be pushed against the edges
of the tray.
IMPORTANT
Run the servo leads out toward the front of the airplane.
❑
While holding the servos in place, drill 1/16" pilot holes
through the servo tray for the mounting screws.
❑
Install the servos using the wood screws provided with
your radio system.
