![background image](http://html.mh-extra.com/html/ac/stag-400/stag-400_installation-manual_454619016.webp)
AC S.A. All rights reserved. Copying, publishing, distribution and any usage of the full or partial data included in the herewith document, particularly pictures, drawings, illustrations, trade marks etc. is
strictly prohibited under the law.
Page 16 of 54
The reducer should be connected to the cooling system with metal tees incorporated into to the
vehicle's heater system (
The volatile phase filter should be attached to non-moving parts of the vehicle, away from the heat
sources (
The PS-02 pressure sensor should be fitted on the gas tube between the volatile phase filter and the
gas injectors (
Picture 1.3.30
PS-02 type sensor
1.3.6
Electronic control unit
The controller should be mounted on a support or directly on the element connected to the vehicle’s
bodywork. It is recommended to install the controller near the engine, were the device will not be
exposed to water or high temperatures. The engine compartment is a typical installation location.
Picture 1.3.31
A view of an installed controller
Picture 1.3.32
A view of the controller’s mounting
elements