CR7P
Digital Proportional Radio Control System
14
6.17Receiver Settings-Failsafe:
6.15 Key Settings
The key setting function is to assign switches to some functions in order to control the output of
the actions needed through the specified switch. According to the types , it includes trim, switch,
and knob.
Function settings:
1.
In the SW ASSIGN(switch assignment) menu, select a item and press the OK key.
2.
Select the item you need to adjust by pressing the UP/DOWN key. Press the OK key to enter the
edit state. Then adjust it by pressing the UP/DOWN. Press return after adjustment .
3.
Test the function to confirm that all channel outputs operate normally as expected.
6.16 Receiver Settings
The RX SET(receiver setting ) menu provides a number of function setting menus to allow you to set
up the receiver system in all aspects . That is , FAILSAFE , BIND SET, RANGE TEST, SENSOR, ESC SET, and
I-BUS SET.
Function settings:
I n t h e m a i n i n t e r fa c e, p re s s t h e O K ke y t o e n t e r t h e fu n c t i o n m e n u . S e l e c t t h e R X S E T ( re c e i ve r
s e t t i n g ) m e n u b y p r e s s i n g t h e U P/ D O W N k e y. P r e s s t h e O K k e y t o e n t e r t h e f u n c t i o n s e t t i n g
interface.
Failsafe is an important safety setting. It can be used to protect the model from loss or reduce
the degree of loss when the receiver loses signal without control. In addition, it plays a role in
protecting personnel safety.
You can set the data in case of loss of control for all output channels . There are three output states .
If the state is not set , the output is low level state. It is mainly for giving you a reminder. The no
output state is also an output of a low level, that is , no signal state. If the output is set , there is
the corresponding output according to your requirements . The specific mode settings depend on the
terminal device and operation requirements . For example, some governors take no signal as the stop
signal. If the out-of-control receiver needs to output a low level no signal, the governor will enter
the protection. Another example: If it is an engine, we need to output a brake signal to the brake
servo if it is out of control, we need to set that there is an output and it is in the brake state.
Summary of Contents for CR7P
