CR7P
Digital Proportional Radio Control System
6
4.4 Calibration
The calibration is required in case of data offset of the transmitter due to physical wear in long -term
operations . At this time, we need to calibrate the output data and neutral angle of the traversing
handwheel, throttle trigger, and VR2.
The transmitter has been calibrated at the factory. If you need to recalibrate it , please follow the
steps below: Please follow the steps below to perform the settings:
1.
Power on the transmitter, enter the system menu, and select the stick calibration function. Follow
the prompts to press the Start key for calibration.
2.
Swing the handwheel and trigger to the maximum and minimum travel in each direction
respectively and then release them. Toggle the VR2 left and right repeatedly to the maximum
extent for two or three times . Finally, toggle the VR2 back to the middle position.
3.
Press the return key to exit the calibration interface. The calibration is complete. If the pop-up
window indicates that the calibration has failed, it means that the control to be calibrated has not
reached the maximum and minimum travel, or VR2 has not been toggled to the middle position.
The re -calibration is required.
4.5 Restoring Factory Settings
When you want to clear the data in the transmitter, you can restore all data in the transmitter to
default values . That is , all model data and setting s are restored to the default state.
Please follow the steps below to restore factory setting s:
1.
Power on the transmitter, enter the system menu, and select the
factory reset function. Follow the
prompts to press the OK button to start the reset .
2.
After the successful reset , the system automatically returns and stays in the system menu
interface. It indicates that the system has been restored to the factory settings .
4.6 Power-off
Please follow the steps below to power off the system:
1.
Power off the receiver.
2.
Turn the switch to the [OFF] position to turn off the transmitter.
Caution
•
When you shut down the system, make sure to power off the receiver, and then the transmitter.
Otherwise, the model may be damaged and people may be injured.
Please follow the steps below to perform the settings:
1.
Start the transmitter and enter the SYSTEM menu. In the SYSTEM settings , set the LED, SOUND,
and VOLUME .
2.
After the settings are completed, return back .
Summary of Contents for CR7P
