31
circuit breaker to open circuit.
Step 2: Ensure the polarity of the solar module connection is correct and
the voltage has not exceeded the maximum input voltage allowed
by the converter.
Step 3: Loosen the DC+ and DC- thread locknuts at the DC input, as shown
in Figure 9.
Step 4: Wire the solar module to the DC input with two sets of wiring or
four sets of wiring according to the arrangement. Based on the
recommended wire diameters, push the wires through the suitable
water-proof plugs (4-hole or 2-hole). Do not damage the
water-proof plug structure to avoid humidity seeping into the
converter interior, as shown in Figures 10 and 11.
Figure 9
DC+ _ two sets of wiring
DC- _ two sets of wiring
Step 2: Ensure the polarity of the solar module connection is correct and
the voltage has not exceeded the maximum input voltage allowed
thread locknuts at the DC input, as shown
Step 4: Wire the solar module to the DC input with two sets of wiring or
four sets of wiring according to the arrangement. Based on the
push the wires through the suitable
hole). Do not damage the
proof plug structure to avoid humidity seeping into the
_ two sets of wiring
Summary of Contents for EnerSolis Series
