13
English
www.abl.de
• Clip the AC current sensor(s) on to the incoming power wires, preferably after the main
fuse, to avoid working on powered wires.
› Maximum single wire thickness is 12mm with insulation.
› If insulated bus bars are used on the output of the main fuse, the AC current
sensor(s) can be mounted before the main fuse. Take extra care during installation
on the input side.
›
Clip on insulated wires only! The AC current sensor is not suitable for uninsulated bus
bars that can be found in some main fuse boards.
›
Warning! Be sure to clip the AC current sensor(s) on to the phase(s) that correspond(s)
to the chosen connection pattern for the charging station(s). See the installation
diagram for your installation in a separate document.
Preferred
Optional
