Installation –
Installing the eMH2 Wallbox on the POLEMH2 |
23
4
Connect a supply cable measuring approximate-
ly 1.5 metres in length to the internal RCCB of the
eMH2.
y
To establish the connection, the grommet of the
wallbox must be cut and the supply cable insert-
ed into the interior of the housing.
1,5 m
5
Replace the electronic components cover onto the
rear shell of the housing and fix it into place with
the screw you removed in
Step 2
and the Torx
screwdriver.
NOTE
Detailed information in the installation instructions
The installation instructions for the eMH2 Wallbox contain detailed information on preparing for the electrical
connection.
6
Remove the large grommet on the front of the
mounting pole, use the cutter to cut an opening for
the supply cable in the membrane of the grommet
and then replace it.
y
If you also want to lay data cables into the
wallbox, cut both smaller grommets, too.
7
Using the hexagon screwdriver, screw the two
M6×16 half-round head screws supplied with the
mounting pole into the two upper fixing points of
the POLEMH2.
y
The distance between the bottom of the screw
head and the mounting plate must be 4 mm
each.
4 mm
