EGO User manual
17
PROCEDURE TO STORE A ROLLING CODE TRANSMITTER
GROUP 2 (BFT)
1) Enter set up
Press and hold key 4 (PROG) then press key sequence 1,2 (pic. A). Green led will start to blink rapidly
(pic. B).
2) Select channel
Press the key (channel) on which you want to store the original transmitter (key 1 for channel 1, pic.
C), both led will be lit steady (pic. D).
3) Program EGO
Press and hold key 1 and 2 (new models) or hidden button (old models) for about 2/3 seconds and
release: led on original transmitter will blink. Transmit seed code keeping the original transmitter
about 5cm far from EGO (pic. E) pressing the key (channel) you intend to store into EGO. When the
code is detected EGO red led goes off and green led will start to blink, at this point you can release
the key. (pic. F).
IMMEDIATELY after press and hold
the original transmitter’s key (channel) until EGO green led
goes off, finally to confirm the success of the procedure the red led will blink for about 3 seconds.
If you want to add another code on a different channel please goes back to step 2 within 3 seconds
(until the green led blinks rapidly).
1
2
4
pic. A
pic. B
1
pic. C
pic. D
PRODUCER
MODEL
BFT
KLEIO TX2, KLEIO TX4, MITTO 2, MITTO 4, RB, RCB2, RCB4, TRC2, TRC4, TX2, TX4
Compatibility table
ROLLING CODE GROUP 2 (BFT)
EGO
pic. E
pic. F
5cm
BFT
FLASH
FLASH
FLASH
>>>
Summary of Contents for EGO
Page 26: ...26 EGO User manual NOTES ...
