18
EGO User manual
4) Add EGO to the receiver
At this point EGO is an emulator of the original transmitter and must be added into the receiver.
Get closer to the receiver and:
a) Press and hold key2, then press and hold key 4 (pic. G) until the red led lights steady, then
release both (pic. H).
b) Press the key (channel) you want to add into the receiver (key 1 for channel 1, pic. I).
Green led will start to blink indicating the initiation of the communication with the receiver,
which can last 25-30 seconds (pic. J).
c) Wait for the receiver feedback (opening gate, lights, …) indicating that EGO has been recognised.
Important
: the receiver may has been set up not to accept new transmitters. In this case for the
correct procedure please refer to receiver manufacturer instructions.
If the procedure fails because the original transmitter is not compatible, after 10 seconds
both led will start to blink alternately.
Seed code
This feature can be used when it is necessary to emulate an EGO / BFT on a new EGO transmitter.
Press and hold key 3, then press and hold key 4. The red led will light steady. Release both keys and
press the key which source code is needed (key 1 for channel 1, pic. below).
3 sec
>>>
pic. G
pic. H
2
4
1
pic. I
pic. J
FLASH
FLASH
FLASH
3
4
1
Summary of Contents for EGO
Page 26: ...26 EGO User manual NOTES ...
