abc PU00, Manual

Page: 32 / 95

30
EN
Control Unit (CU) + Power Unit (PU) = AD800 Frequency
ENGLISH
1. Summary

The power unit (PU) of the AD800 can be used independently or in combination with a different
control unit (CU) or Keyboard;

For control unit (CU) or keyboard control function description, please refer to the control unit
(CU) or keyboard quick guide.

The products are strictly tested and packaged before leaving the factory, if any abnormalities
such as damage, wrong type and lack of accessories, please contact with our sales.
2. Safety information

Before operating this product, please read and pay attention to the relevant safety
information, and install, debug, repair and maintain by professionals.

When operating the wiring, please make sure that the power is off.

After turning off the power, there may still be high voltage inside the power unit. Do not
touch the internal circuit and the main circuit terminals. Otherwise, there may be a risk of
electric shock. Wait at least 4 minutes (≤22kW) and 15 minutes (≥30kW) before operating.

Never plug or remove any connector of the product when the product is powered, doing so
may lead to product damage or humane injury or death.

The grounding terminal of product must be properly grounded.

The main circuit terminals must be correctly wired. R, S, and T or R/L, S, T/N are power
input terminals. Never mix them with U, V, and W. Otherwise, the product will be
damaged when power on.

Products and accessories should be installed away from fire source and flammable
materials.

the motor power is only allowed to be one level higher or two levels lower than the rated
power of the inverter. Otherwise it may result in reduced control performance or motor
burnout.

Please set the motor parameters correctly according to the motor nameplate ， then set
P1-13 = 1 or 2 to start self-learning. Otherwise may cause the motor to burn out.