Abbott Diagnostics Aeroset, Customer Training Manual, Page: 364 / 456

MODULE 10: MAINTENANCE
10-12
AEROSET
®
Customer Training Guide
94858-103 — July 2003
Quarterly Maintenance Activity
Introduction
In this exercise, you will perform the Quarterly Maintenance Procedures.
Objective
Upon completion of the Quarterly Maintenance Activity, you will be
familiar with:
• Replacing the Syringe Seal Tip and O-Ring on sample, reagent, and
wash solution syringes
• Replacing the 1 mL wash solution syringes
• Replacing the 1 mL ICT™ reference solution syringe
• Replacing the 1 mL ICT aspiration syringe
• 0.22 Micron Filter replacement (if applicable)
Necessary Materials
• AEROSET System Operations Manual
NOTE: The materials for each procedure are defined in
the AEROSET System Operations Manual .
Procedure
The information for the following steps is found in the AEROSET
System Operations Manual .
Refer to Component Replacement in Section 9, Service and
Maintenance of the AEROSET System Operations Manual to
perform the following procedures:
1. Syringe Seal Tip and O-Ring replacement on sample, reagent, and
wash solution syringes
2. 1 mL Wash Solution Syringe replacement
3. 1 mL ICT Reference Solution Syringe replacement
4. 1 mL ICT Aspiration Syringe replacement
5. 0.22 Micron Filter replacement (if applicable)
Instructor will need the
following for demo:
- Flathead screwdriver
- Phillips screwdriver
- 7mm wrench
- absorbant towels
- cotton swabs