ABB TZIDC-110, Short Manual, Page: 9 / 44

Installing and commissioning
41/18-77 EN Installing and commissioning 5
3.1.2 Operating conditions at the installation site
Ambient temperature: -40 ... +85 °C (-40 ... +185 °F)
Relative humidity < 75% (95% for a short time), non-condensing
Observe the specifications for protection class
IP65 / NEMA 4X
Explosion protection: Observe the specifications in the certificate, see section
“Certificates” on page 29.
Mounting position: any orientation allowed, provided that the splash guard
cap is in place, see section “Mounting the splash guard
cap” on page 15.
3.1.3 Mounting to linear actuators
A special attachment kit is available for mounting the positioner to a linear actuator
according to DIN/IEC 534 (lateral mounting to NAMUR) comprising the following parts:
Tools required: Wrench 10 mm/13 mm
Allen key 4 mm
• Lever (1.0) w. follower
pin, for 10...35 mm or
25...90 mm actuator
stroke
• Follower guide (2.0)
with two screws (2.1)
and clamp plates (2.2)
• Angle bracket (3.0)
with two screws (3.1),
two spring washers
(3.2), and two plain
washers (3.3)
• Screw (3.4) and plain
washer (3.5) for
mounting to cast iron
yoke
• Two U-bolts (3.7),
each with two nuts
(3.8), two spring
washers (3.9), and
two plain washers
(3.10) for mounting to
columnar yoke
Before installing check to ensure that the specifications in terms of safety
and control applicable to the TZID-C110 will not be exceeded.
Warning
3.4
3.5
3.7
3.10
3.8
3.1 3.2 3.3
3.0
2.1
2.2
2.0
1.0
3.9