ABB TZIDC-110, Short Manual

Page: 23 / 44

Installing and commissioning
41/18-77 EN Installing and commissioning 19
3.4 Commissioning
3.4.1 Commissioning procedure
1. Turn on the air supply to the positioner.
2. Connect the bus to the bus terminals, with arbitrary polarity.
After the device has started up, the display indicates the position in % and
REMOTE.
3. Check for proper mounting:
- Press and hold
M
ODE
and
E
NTER
simultaneously.
- Wait until the countdown has run down from 3 to 0.
- Release
M
ODE
and
E
NTER
.
The operating level (mode 1.x) is reached and
indicated.
- Press and hold
MODE
.
- Additionally briefly press or until mode 1.3 (manual adjustment within the
sensor range) is displayed.
- Release
MODE
.
- Press or to move the actuator to its mechanical limit stops in both directions,
and note the values. The angle of rotation is indicated in degrees.
4. Return to the remote level.
- Press and hold
MODE
and
ENTER
.
- Wait until the countdown has run down from 3 to 0.
- Release
MODE
and
ENTER
.
- The display indicates the position in % and REMOTE.
See Appendix A for an overview of the operation and the parameter settings.
5. Run fast Autoadjust .
- Make sure that the remote level is activated.
a) For linear actuators:
- Press and hold
MODE
.
- Wait until the countdown has run down from 5 to 0.
- Release
MODE
.
- Press and hold
MODE
again until the countdown has run down from 3 to 0.
- Release
MODE
.
Autoadjust is started automatically, and the progress is displayed as in P1.1.
Recommended range is
between -28° and +28° for linear actuators
between -57° and +57° for rotary actuators
Minimum angle: 25° (in case of deviations from these values see chapter 3.1)