14
| 2105551-001 rev. AC
Table 10: TFIO analog input module (M2)
J1
J2
J3
J4
1 AI1 (+)
AI3 (+)
AI5 (+)
AI7 (+)
2 AI1 (GND)
AI3 (GND)
AI5 (GND)
AI7 (GND)
3 AI2 (+)
AI4 (+)
AI6 (+)
AI8 (+)
4 AI2 (GND)
AI4 (GND)
AI6 (GND)
AI8 (GND)
Table 11: TFIO combo digital module and extended (M2)
J1
J2
J3
J4
1 POINT 1 SIG
POINT 3 SIG
POINT 5 SIG
POINT 7 SIG
2 POINT 1 GND
POINT 3 GND
POINT 5 GND
POINT 7 GND
3 POINT 2 SIG
POINT 4 SIG
POINT 6 SIG
POINT 8 SIG
4 POINT 2 GND
POINT 4 GND
POINT 6 GND
POINT 8 GND
Table 12: TFIO thermocouple module (M2)
J1
J2
J3
J4
1
Shield Shield Shield Shield
2 TC1 (J-Wht/K-Yel)
TC2 (J-Wht/K-Yel)
TC3 (J-Wht/K-Yel)
TC4 (J-Wht/K-Yel)
3 TC1 Red (-)
TC2 Red (-)
TC3 Red (-)
TC4 Red (-)
4
Shield
Shield Shield Shield
Table 13: TFIO RTD module (M2)
J1
J2
J3
J4
1
OUT OUT OUT OUT
2
(+) (+) (+) (+)
3
(-) (-) (-) (-)
4 IN
IN
IN
IN
See section 9,
Configuring TFIO interfaces
to configure the TFIO interfaces.
5 Powering
the
RMC
This section describes two modes for powering the controller:
— Battery mode: power is supplied by a 12 volt battery with a charger (see section
5.2,
Powering with battery and charger.
)
— External power mode: power is supplied by an external power source (see
section 5.3,
Powering with external power.
)
Review section 5.1,
Power on sequence
, follow the instructions for the appropriate
power mode and continue to section 5.4,
Lithium battery
.
